MORTON.
Morton Powder Coatings
SERIES FOR THE OIL & GAS INDUSTRY
General Description
CORVEL® 10600 Series epoxies and modified epoxies are specifically designed to protect the inside diameter (I.D.) and outside diameter (O.D.) of tubular goods from the corrosive environments encountered in the oil & gas industry. 10600 Series coatings for internal tubular protection, when applied over abrasive blasted (NACE #1 White Metal Blast) and phenolic primed steel surfaces, demonstrate successful laboratory and field performance in downhole environments. Typical applications include drill pipe, production tubing, injection and disposal systems, distribution piping, sucker rods, valves, and metering systems.
TYPICAL PIPE COATING PERFORMANCE CHARACTERISTICS
PROPERTY 10-8158 Tan 10-6051 Green Specific Gravity calculated 1.57 1.71 Impact Resistance
ASTM G-14160 in.lbs. 100 in.lbs. Flexibility
4 point bend @ 75°F (23.9°C)6=/PD 3=/PD Thickness 10-15 mils 10-15 mils Service Temperature maximum 225°F (107.2°C) 350°F (176.7°C) Corrosion Control I.D. I.D. Preheat Temperature 325° - 400° F
(162.8°-204.4° C)325°- 400° F
(162.8°-204.4° C)Cure Schedule 30 minutes @ 400°F (204.4°C)
20 minutes @ 425°F (218.3°C)30 minutes @ 425°F (218.3°C)
Product Selection
CORVEL 10600 Series epoxy coatings for internal corrosion protection have been extensively tested in the field and evaluated under various autoclave test conditions. Special autoclave tests using any combination of temperature, pressure, and environment can be performed to assist in material recommendation. The general data as listed will provide a guide for your application. Consult your Morton Powder Coatings sales representative and perform your own tests to determine which product is suitable for your requirements.
Precautions
It is recommended that the area adjacent to the coating operation to properly ventilated and that cure ovens are exhausted to the outside atmosphere. Since all dusts are respiratory irritants, inhalation should be avoided. If skin contact occurs, wash with soap and water. In the event of eye contact, flush with water immediately and seek medical attention. Dust clouds of any finely divided organic material can be ignited by electrical sparks or open flame. Dust collection equipment should be provided with adequate explosion venting. All equipment should be grounded to avoid buildup of static electricity.
Storage
Fine powders are hygroscopic and should be stored in sealed containers when not in use. CORVEL coatings are designed to have excellent package stability. To ensure maximum shelf life, store in dry conditions at temperatures less than 70F (21.1°C)
Important: Warranty and Disclaimer-The performance characteristics of these products vary according to product application, operating conditions, materials applied to or with and use. Since these factors can affect results, we strongly recommend that you make your own test to determine to your satisfaction whether the product is of acceptable quality, has not been affected by storage or transportation and is suitable for your particular purpose under your own operating conditions prior to using any product in full scale production. Seller warrants the products to be free from defects in materials and workmanship. Such warranty is exclusive and is in lieu of any other warranty, express or implied, including but not limited to any implied warranty of merchantability of fitness for a particular purpose. No representative of ours has authority to waive or change this provision, which applies to all sales of these products.