POWDER COATING DATA SHEET
CORVEL® EP-10 PRIMER
PRODUCT DESCRIPTION
CORVEL EP-10 Primer, 1P-0010, is a phenolic based liquid coating designed for priming the inside diameter of pipe prior to the application of high performance CORVEL® epoxy powder coatings.
|
Color |
Red |
LIQUID PROPERTIES
| PROPERTY | TEST METHOD | RESULTS |
| Weight/gallon Viscosity % Solids by Weight Flash Point |
#2 Zahn Cup ASTM D 93 |
9.9 lbs/gal. (1.15 kg/l) 16.21 seconds 47.7% 64°F (17.8°C) |
RECOMMENDED APPLICATION (0.7 mil. average)
| Substrate Preparation Anchor Profile Application Reducing Solvents |
NACE #1 White Metal Blast Minimum 1.5 mil sharp, dense Spray or Brush 14°F (-10°C) to 170°F (76.7°C) Methanol, Ethanol, Butanol (as required by applicator) |
Less than optimum adhesion may result if primed substrate is preheated longer than one hour at 320°F (160°C) or 10 minutes at 425°F (218.3°C).
CAUTIONS
Contact with CORVEL EP-10 Primer may cause skin irritation. Synthetic gloves and organic vapor masks are recommended precautions. Keep away from sparks and open flames. Adequate ventilation is necessary in the workplace. 18Jun98
Important: Warranty and Disclaimer-The performance characteristics of these products vary according to product application, operating conditions, materials applied to or with and use. Since these factors can affect results, we strongly recommend that you make your own test to determine to your satisfaction whether the product is of acceptable quality, has not been affected by storage or transportation and is suitable for your particular purpose under your own operating conditions prior to using any product in full scale production. Seller warrants the products to be free from defects in materials and workmanship. Such warranty is exclusive and is in lieu of any other warranty, express or implied, including but not limited to any implied warranty of merchantability of fitness for a particular purpose. No representative of ours has authority to waive or change this provision, which applies to all sales of these products.
#5 Commerce Drive Flying Hills Corporate Center P.O. Box 15240 Reading, PA 19612 (610) 775-6600
Home-Morton Powder Coatings Page 2 Page 3-Oil & Gas Industries